BS EN ISO 179-1-2001 impact testing machine for simple supported plastic beams with digital display - determination of impact properties of simple supported plastic beams - GBT 1043.1-2008 - part 1:The instrumented impact test ", "GB 1451-2005 fiber reinforced plastic beam type impact toughness test method", "the JBT plastic beam impact testing machine, 8762-1998 standard, is suitable for hard plastic, fiber reinforced composite materials, nylon, glass fiber reinforced plastic, ceramic, cast stone, asbestos board, electrical insulating materials and other non-metallic materials impact toughness test.
USES high-grade MCU with stable embedded operating system, through the data acquisition of high resolution encoder, get the Angle of the impact hammer information, and at the same time control actuator output impact action, the action in the process of automatically obtain the result of the impact energy, and according to the result of impact energy and sample parameters automatically calculate the sample standard impact strength, in the process of operation can automatically record the impact of each operation as a result, and average on the same set of samples, etc.Very convenient to use, compared with the dial beam impact testing machine, do not need to calculate, the reading is intuitive, and can be stored, read at any time.Equipped with miniature desktop printer, can print test results at any time.
ASTM D6110 ASTM D256 Charpy Impact Resistance Test Machine Of Plastic
This machine adopts single chip microcomputer control, liquid crystal Chinese display, flexible and convenient operation, high control accuracy.
The energy loss caused by friction and wind resistance is automatically corrected without manual calculation.
The energy absorbed by the modified sample can be directly displayed to improve the accuracy and efficiency of the test.
After each test, the impact energy is calculated and displayed automatically.
After the test is completed, the energy value and average energy value of each impact sample are displayed.
Main technical indicators:
The number type ：5 j
Impact speed: 2.9m/s
Pendulum energy 0.5j (optional), 1J (optional), 2J, 4J, 5J
The strike center distance is 230mm
The pendulum raises Angle 150°
Radius of blade fillet R=2±0.5mm
The rounded corner radius of the clamp mouth R=1±0.1mm
The Angle of impact blade is 30±l°
Energy display resolution 0.01J
Clamping hole support spacing (mm) 40, 60, 62, 70
Overall dimension (mm) 420×260×630