Sand and dust test chamber is suitable for all kinds of auto parts to do dust and dust test, test parts include car lights, instruments, electrical dust cover, steering system, door locks, etc.It is mainly used for testing of IP5X and IP6X specified in the enclosure protection grade standard.Mainly is the simulation sandstorm weather to lock, auto parts, seals, power meters and other products caused by damage.
This product is designed and manufactured in strict accordance with the corresponding national standard technical parameters, such as gb2423.37-89la shell dust protection 2·1, gb7001-86 lamp shell protection 4.4.1, gb10485-89, etc. to simulate dust environmental test.
1. Temperature with RKC waalwijk, DC type temperature controller, can adjust in the RT + 5 ℃ ~ 60 ℃, prevent the dust in the air moisture influences in the cabinet, damp, can take the test at the same time the humidity control in the cabinet below 50% r. H;
2. The test tank and control cabinet are all-in-one, and casters are installed on the lower part. Other systems are hidden, beautiful and elegant, and easy to install;
3. The sample can be directly added into the box with dust. When it is replaced, the valve should be opened at the bottom of the box funnel, which can be discharged in a short time, saving the trouble of manual material replacement by operators.
4. The temperature inside the box is protected to prevent runaway temperature control from affecting the test.
Inner box size: 600 * 600 * 600MM
Vacuum pump: 0-30kpa (IP6) selection
Timing accuracy: 1 min
Air pressure: 0.5 ~ 1.0mpa
Timing range: 0-99 hours and 99 minutes
Height adjustment range of sample rack net: 0 ~ 750MM
Ash blowing cycle control: 1S ~ 9999 minutes
Airflow velocity: ≦2M/S
Specification of test sand: sieve hole 75UM, wire 50UM
Sand consumption: 2KG/M3
Load cycle control: 0-99 hours and 99 minutes